PCB & Layout
- Advanced Altium Designer work
- 2–6 layer stack-up planning
- Impedance control and length matching
- Design referencing IPC-2152 / IPC-2581
- Gerber, BOM and Pick&Place production set
About
Hardware design and R&D engineering — from concept to a board that works in the field.
I have been working in electronic hardware design and R&D for over seven years. I take on the whole job: from requirement analysis to schematic design, from multi-layer PCB layout to prototype build, measurement and failure analysis.
At ANSATEK Engineering, which I founded in 2019 with TÜBİTAK 1512 support, I ran hardware development and R&D end to end for six years and completed three R&D projects. In that period I designed across a wide range — from industrial control boards to battery management systems, sensor-fusion modules and high-speed SoC boards.
I approach IoT from a hardware and systems perspective rather than a software-first one. I have worked on sensor integration, hardware architecture and productisation on embedded platforms such as Raspberry Pi, LattePanda and NVIDIA Jetson. My priority has always been field reliability, stability and measurable performance.
Capabilities
Technical areas
Embedded & Control
- STM32 / ARM Cortex-M, AVR, Arduino
- Raspberry Pi, Jetson, LattePanda integration
- UART, SPI, I²C, CAN, USB
- Modbus RTU/TCP, RS-485
- Hardware-software integration
Power & Analog
- SMPS: Flyback, Buck-Boost, LLC
- Motor driver and gate driver stages
- High-current routing and thermal design
- Low-noise analog measurement chains
- Galvanic isolation and protection circuits
Verification & Test
- EMI/EMC, signal integrity, crosstalk analysis
- LTspice, PSpice, Multisim simulation
- Oscilloscope, logic analyzer, power analyzer
- Prototype assembly and failure analysis
- Test procedures and technical documentation
Tools I use
Experience
Work history
Dec 2025 – Mar 2026
Project Specialist / Technical Consultant
Ministry of Transport and Infrastructure — Directorate General for EU and Foreign Relations, Ankara
Automatic passenger counting system within an EU/IPA-funded public transport project: technical specifications, supplier evaluation and technical procurement.
2019 – 2025
Founder & Hardware Engineer
ANSATEK Engineering and Consulting
End-to-end electronic hardware development, multi-layer PCB design and R&D process management. Signal and power integrity, EMI/EMC, prototyping, test and hardware-software integration.
2023 – 2024
Technology Consultant
Erzurum Technical University — Kristal Entrepreneurship Center
Technical evaluation and strategic guidance on R&D and entrepreneurship projects; university-industry collaboration, mentoring and project preparation.
2017 – 2019
Hardware Design Engineer (project based)
Electronics R&D work
Control boards, power electronics circuits, prototyping and test work.
Education
Education and internship
2016 – 2022
BSc Biomedical Engineering
Erciyes University, Kayseri
2012 – 2014
Biomedical Device Technologies (Associate)
Akdeniz University, Antalya
2020
Biomedical Engineering Internship
Dräger Medical, İstanbul
Have a hardware idea?
Let's talk through the scope and technical constraints — I'll come back with a clear picture of the steps and the time it takes.